Soaking-wet clothes at the end of a cycle mean the washer did not spin effectively or did not remove water correctly. An unbalanced load, overloading, a blocked drain filter or hose, and pump or drive faults are common causes; first check whether visible water remains in the drum.
If water remains in the drum, start with drainage
Run a drain or spin cycle once and listen for pump operation. Check for a kinked hose and an accessible filter with the washer unplugged; do not keep restarting if the pump hums without moving water.
If the drum is empty, check balance and load size
A single heavy item or an overfilled drum can cause the control to reduce or cancel spin speed. Redistribute the load and test with a normal amount rather than adding more items to compensate.
Excess suds can also interfere with spinning
Too much detergent or the wrong product for the washer can leave excessive suds and trigger extra rinsing. Adjust the dose for load size, water hardness, and concentration; do not add fabric softener in an attempt to break the suds.
If the drum cannot reach spin speed, it needs diagnosis
A motor, belt, sensor, door lock, or drive fault can prevent spinning even when water drains. If the door locks normally but the problem persists with a normal load, arrange service rather than opening energized panels.
Sources
- American Cleaning Institute — Cleaning Tips — General household-cleaning practices and responsible product use.